Faulty Signal

Faulty signal

Information about symptom fault-tracing
The diagnostic trouble codes (DTCs) are included in a larger fault-tracing for the symptom Starter motor not running.
Add the symptom and fault trace according to Checking the start system.
If this has already been carried out, continue fault tracing.

Do you want to continue with this procedure?

Yes - Programming control module

No - Exit fault-tracing

-------------------------------------------------

Programming control module
The diagnostic trouble code is generated when Central Electronic Module (CEM) registers that Steering Column Lock Module (SCL) is not programmed correctly.

Note! The Steering Column Lock Module (SCL) cannot be programmed. The control module must be replaced and a new control module programmed.

Other information
- Steering lock Steering Wheel Lock, Replacing

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
Check the operation of the steering column lock. Insert the ignition key in the ignition switch. The steering column lock must then be unlocked. It must be possible to turn the steering wheel.

Can the steering wheel be turned?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Programming control module

-------------------------------------------------