Engine Block, Installing Components

Engine block, installing components

Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential information in the illustrations is always correct.

Installing engine block components

Note! Always use new seal washers and gaskets!

Install
- thermostat housing (B52x4x)
- knock sensor (KS)
- flame trap
- the pipe screw for the water-heated crankcase ventilation.
B5xx4x. Engine body, exposing, B5254T2 Engine Body, Exposing
B6xx4x. Engine body, exposing, B5254T2 Engine Body, Exposing

Install the flywheel and carrier plate. See Crankshaft seal rear, replacing .
B5xx4x. Tightening torque Tightening Torque
B6xx4x. Tightening torque Tightening Torque

The ignition coil alignment and the wiring routing follows the illustrations below.

B5xx4x





B6xx4x