Centre Loudspeaker

Centre loudspeaker















INTRODUCTION
- NOTE! Read through the whole installation instruction before starting the work.
- The front page gives the date of this edition and the edition it replaces
- The second page shows the tools needed for the installation and the contents of the installation kit
- The illustrations display the procedure in order of operation. The order of operation is repeated in the text section
- Cut out the text page in order to follow the illustrations and text at the same time.






Centre loudspeaker

- Turn the ignition key to position 0.

Illustration A




- Remove the loudspeaker grille as follows: Insert tool P/N 999-5919-46 into the joint between the loudspeaker grille and the dashboard as illustrated, until it engages
- Twist the tool 90° so that the bent section engages with the underneath of the loudspeaker grille.

Illustration B




- Pull upwards until the loudspeaker grille detaches. The loudspeaker grille is securely fastened by four clips. Move the tool closer to the clip to facilitate removal.

Note! Do not damage the dashboard.




- Remove the carpet covering the hole under the loudspeaker grille. Discard it, it will not be reused.




- Take the loudspeaker and six screws from the kit
- Connect the pre-routed connector to the loudspeaker
- Install the loudspeaker in the hole in the dashboard. Tighten using the six screws
- Press the loudspeaker grille into place.