Checking the Winter Mode

Checking the winter mode





- Ignition on
- Check the winter mode function by clicking on the VCT2000 symbol
- Start reading off the winter mode status
- Press in the winter position (W) button.
The status must change between Normal mode/Winter mode.
If the status does not change, try replacing the printed circuit board in the gear selector assembly.





Does the status change?

Yes - Procedure complete

No - Verification

-------------------------------------------------

Verification





- Ignition on
- Check the winter mode function by clicking on the VCT2000 symbol
- Press in the winter position (W) button.
The status must change between Normal mode/Winter mode.





Does the status change?

Yes - Procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the winter mode

-------------------------------------------------