End Pipes

End pipes



















INTRODUCTION
- NOTE! Read through the whole installation instruction before starting the work.
- The illustrations display the procedure in order of operation. The order of operation is repeated in the text section.






End pipes




- Clean the silencer's end pipes.




- Ensure that the marked areas around the pipes, where the clamp for the end pipes is to be tightened, is clean.




- Insert the end pipes on the silencer's pipe.




- Install the clamp from the kit, take the screws and loosely tighten the end pipes.
- Adjust the clamp so that it is properly secured in the recesses in the silencer pipes.
- Secure the end pipes. Tighten the screws to 24 Nm (18 lbf.ft.).