Sunroof / Moonroof Module: Service and Repair

Control module, sunroof, replacing

As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the essential information in the illustrations is always correct.

Preparations




Close the sunroof.
Ignition off.




Remove the key.

Note! After removing the key, wait one minute before starting work.

Removing the sunroof control module





Remove:
- the upper electronic module (UEM). See Upper electronic module (UEM)/rearview mirror, replacing Upper Electronic Module (UEM)/Rearview Mirror, Replacing
- the first connector
- 1 screw.
Detach the control module and lift it down.

Remove:
- the second connector
- the control module for the sunroof.

Installing the sunroof control module

Note! For tightening torques, see Specifications [1][2]Body and Frame.

Install:
- the small connector
- the control module
- 1 M6 screw. Tighten
- the large connector
- the upper electronic module (UEM). See Upper electronic module (UEM)/rearview mirror, replacing Upper Electronic Module (UEM)/Rearview Mirror, Replacing.
Calibrate the control module for the sunroof. See Sunroof module (SRM), calibrating Programming and Relearning.