Signal Missing. Intermittent Fault

Signal missing. Intermittent fault

Checking the wiring
Check the signal cable between rear electronic module (REM) connector #B06 (#D6) and tilt sensor connector terminal #2. Check for an intermittent short-circuit to ground.
Also check both connectors for intermittent contact resistance and oxidation.
If no fault was found, try a new sensor.

Other information
- For further information about signals and other values, see Signal specification Signal Specification
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box
- To access the rear electronic module (REM), see Relay/fuse box cargo compartment/Rear electronic module (REM), replacing Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing
- To access and replace the tilt sensor, see Tilt sensor alarm, replacing Service and Repair
- Checking wiring and terminals Checking Wiring and Terminals.









Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Exit Fault-Tracing

------------------------

Attempt New Test - Checking the wiring

-------------------------------------------------