Signal Too High. Permanent Fault

Signal too high. Permanent fault

Checking the relay




- Ignition off.
Check that relay 2/63 is installed correctly. At the same time check the relay connections, in particular 2/63 2, for a short circuit to voltage supply as described in Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.

Additional information:
- To replace relay, see Central electronic module (CEM), replacing Service and Repair
- To connect the test box, see Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM).













Is there a fault?

Yes - Verification

No - Replacing the component

-------------------------------------------------

Replacing the component
Replace relay as described in Central electronic module (CEM), replacing Service and Repair.

Press Continue.

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After the repair it is necessary to check that the fault has been rectified.








- Ignition off.
- Connect the connectors, install the components, etc.
- Ignition on.
Read main beam relay.
Activate main beam.
With main beam on, the value should be "on" and when main beam is switched off, the value should be "off".





Does it work?

Yes - Troubleshooting procedure complete

No - Trouble-shooting information

-------------------------------------------------

Trouble-shooting information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the relay

-------------------------------------------------