Signal Too High/Low

Signal too high / low

Checking the cable








- Ignition off
- Disconnect the connector for the treble loudspeaker in the right-hand D-post
- Disconnect the 16-pin connector for the audio module (AUD).

Hint: The treble loudspeaker in the right-hand D-post and the loudspeaker in the right-hand rear door are connected to these signal cables. For further information, see the wiring diagram.

Check the cable terminals in the female and male sections of the connector. The cable terminals must not be damaged or pressed back.
Check the signal cable between audio module (AUD) terminal #B5 and loudspeaker terminal #2 in the right-hand D-post. Check for a short-circuit to ground. Check for a short-circuit to supply voltage.
Check the signal cable between audio module (AUD) terminal #B13 and loudspeaker terminal #1 in the right-hand D-post. Check for a short-circuit to ground. Check for a short-circuit to supply voltage.
Remedy as necessary.

Other information:
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Audio Module (AUD)
- To access or replace the audio module (AUD), see Audio module (AUD), replacing Audio Module (AUD), Replacing
- To access or replace the loudspeaker in the rear side door, see Loudspeaker, rear side door, replacing Loudspeaker, Rear Side Door, Replacing
- To access or replace the loudspeaker in the D-post, see Loudspeaker, D-post, replacing Loudspeaker, D-Post, Replacing
- For information about signals, see Signal specification Signal Specification, Audio Module (AUM)
- Checking wiring and terminals Checking Wiring and Terminals.









Select Continue

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that sound can be heard from the loudspeakers from the Audio module (AUD) by trying the radio FM/AM, CD or MD player.

Do the loudspeakers work?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the cable

-------------------------------------------------