Configuration Fault

Configuration fault

Fault-tracing information
Diagnostic trouble code (DTC) ATM-0002 is stored if the antenna module (ATM) detects a TMC receiver even though the car is not configured for one. A possible cause of the fault is that a TMC receiver has been installed but the car configuration file has not been updated.
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults can be caused by interference at start up of the antenna module (ATM) or may be a different type of fault which occurs on different occasions. The fault is evaluated depending on how it occurs.
Remedy as necessary for permanent faults.

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.

Hint: Use a battery charger if the engine is not running.

Check that the traffic messages are correctly displayed in the navigation system. It may be necessary to zoom out to display a larger area of the map. Traffic message information is transmitted every 15 minutes.

Hint: This fault-tracing cannot verify whether traffic information is transmitted in a particular area.

Are the traffic messages displayed correctly?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Exit Fault-Tracing

------------------------

Attempt New Test - Fault-tracing information

-------------------------------------------------