Spoiler, Rear, Replacing

Spoiler rear, replacing

Special tools:
951 2942 Circle 951 2942 Circle
951 2949 Holder 951 2949 Holder

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removing spoiler




Remove the spoiler by carefully heating up the area for the tape.
Use a hot-air gun while carefully lifting the spoiler using a weatherstrip tool. Start at one end of the spoiler.

Caution! Do not heat for too long, the paintwork on the tailgate plastic cover can be damaged.Two people are required when removing the spoiler to minimize the risk of damage to the paintwork and the spoiler.

Remove any tape residue. Use:951 2942 Circle 951 2942 Circle and:951 2949 Holder 951 2949 Holder.

Hint: In the event of large quantities of tape residue, the tape can be removed from the tailgate by pulling it off at an angle of 45 degrees to the tailgate.

Installing the spoiler




Ensure that the car is at least at room temperature (above 20 °C).
Wash the area for the spoiler. Use a 50/50 mixture of isopropanol and water.
Wipe dry using a clean lint-free cloth.

Caution! In order for the spoiler to adhere, the surface must be clean and free of dust and grease.




Y0 = center of the hatch
M1 at Y0 = 43 mm

Hint: Measure Y0 using the center of the license plate or the holes for the license plate if it is not present.

Note! The Y0 measurement must be correct in order for the spoiler to be centered on the tailgate.

Mark the position of the spoiler using pieces of tape instead of drawing.
Measure the position of the ends of the spoiler using the dimensions given below.




Cut through the backing on the tape.
Loosen the backing approximately 100 mm in each direction, measured from the center of the spoiler.
Fold out the backing so that it can be removed as the spoiler is installed.

Note! Press the whole spoiler to ensure the tape is in good contact with the base.




M1 at both ends of the spoiler = 43 mm
M2 = 14 mm
The M3 measurement must be the same on the left and right-hand sides.
Check that the tape on the spoiler is in contact with the tailgate.

Note! To ensure optimal adhesion, do not wash the car for 72 hours.