Checking Ground Lead to Control Panel

Checking ground lead to control panel

Checking ground leads to the control panel

Hint: None of the control buttons work if there is an open-circuit in the cable.

Check the cable between connector C terminal #6 and ground and terminal #7 and ground. Check for an open-circuit. See Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault. Check for a short-circuit to supply voltage. See Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Remedy as necessary.
If no fault is found in the wiring replace control panel.

Other information:
- To replace the control panel, see Side panel, replacing Removal and Replacement
- For information about connectors / signals, see Signal specification, Power seat module Signal Specification, Power Seat Module (PSM).





Continue - Fault Found

-------------------------------------------------