Checking the Reversing Light (2)

Checking the reversing light (2)

Checking the relay
Check relay 2/80 operation by activating and deactivating the relay several times. The relay is working if a clicking noise is heard when activating and deactivating.
If the relay is not working, replace it with a new relay.

Additional information:
- To access relay/fuse box in the boot, see Integrated relay/fusebox cargo compartment/Rear electronic module (REM), replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing.









Is there a fault?

Yes - FAULT FOUND

No - Checking the wires

-------------------------------------------------

Checking the wires
Check the wires between fuse 11D/4 2 and relay 2/80 5 and relay 2/80 3 and left and right upper lamp body contact 3 for short circuit to voltage supply as described in Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Do the necessary corrective action.

Additional information:
- For information about signals and other values, see Signal specification Signal Specification
- To connect the test box, see Connecting the breakout box Connecting Breakout Box, Rear Electronic Module (REM)
- To access relay/fuse box in the boot, see Integrated relay/fusebox cargo compartment/Rear electronic module (REM), replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing.









Is there a fault?

Yes - FAULT FOUND

No - No Fault Found

-------------------------------------------------