Internal Fault

Internal fault. Permanent fault

Replacement of supplemental restraint system (SRS) control unit and programming




The supplemental restraint system (SRS) control unit has registered an internal fault.

Caution! A new supplemental restraint system (SRS) control unit is supplied without software. The new control unit must be programmed before it will work.

For information on programming and replacement of the supplemental restraint system (SRS) control unit, see Supplemental restraint system module (SRS), replacing Service and Repair.

Continue - Trouble-shooting information

-------------------------------------------------

Trouble-shooting information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Exit fault-tracing

------------------------

Attempt New Test - Replacement of supplemental restraint system (SRS) control unit and programming

-------------------------------------------------