Cable Fault. Permanent Fault

Cable fault. Permanent fault

Checking the component and wiring




- Ignition off.

Caution! Do not touch the terminal pins in the SRS control module. There is a risk of static discharge which could damage the SRS control module.

Check the cable between the SRS and the terminal of the side impact sensor connector according to the following:

for diagnostic trouble code (DTC) SRS-00B0,
front left side impact sensor #8A(8), #9A(9) and connector #1, #2.

for diagnostic trouble code (DTC) SRS-00B5,
front right side impact sensor #8C(4), #9C(5) and connector #1, #2.

for diagnostic trouble code (DTC) SRS-00BA,
rear left side impact sensor #27A(27), #28A(28) and connector #1, #2.

for diagnostic trouble code (DTC) SRS-00BF,
rear right side impact sensor #27C(23), #28C(24) and connector #1, #2.
for a short-circuit to supply voltage according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault and for a short-circuit to ground according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Remedy as necessary.

Other information:
- To access / replace the SRS control module and connector, see Supplemental restraint system module (SRS), replacing Service and Repair.
- To access/replace the side impact sensor, see Collision sensor, replacing Service and Repair.
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Supplemental Restraint System Module (SRS).
- For other values, see Signal specification Signal Description, Supplemental Restraint System (SRS) Control Unit.









Select "Continue" when the fault has been remedied.

Continue - Verification

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the component and wiring

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition off
- Disconnect the battery negative lead
- Reinstall the connectors, components etc.
- Ignition on
- Connect the battery negative lead.

Warning! There must not be anyone inside the passenger compartment when the battery is connected.

- Read off diagnostic trouble codes (DTCs).
The fault is no longer present if the diagnostic trouble code (DTC) status is intermittent.





Is the diagnostic trouble code (DTC) intermittent?

Yes - Verification completed

No - Fault-tracing information

-------------------------------------------------