Cable Fault. Intermittent Fault

Cable fault. Intermittent fault

Intermittent fault




- Ignition off.

Caution! Do not touch the terminal pins in the SRS control module. There is a risk of static discharge which could damage the SRS control module.

Check the connector for the SRS module and for the side impact sensor for contact resistance and oxidation and remedy according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults and loose connections according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check the cable between the SRS and the terminal of the side impact sensor connector according to the following:

for diagnostic trouble code (DTC) SRS-00B0,
front left side impact sensor #8A(8), #9A(9) and connector #1, #2.

for diagnostic trouble code (DTC) SRS-00B5,
front right side impact sensor #8C(4), #9C(5) and connector #1, #2.

for diagnostic trouble code (DTC) SRS-00BA,
rear left side impact sensor #27A(27), #28A(28) and connector #1, #2.

for diagnostic trouble code (DTC) SRS-00BF,
rear right side impact sensor #27C(23), #28C(24) and connector #1, #2.
for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults and an intermittent short-circuit to ground according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Remedy as necessary.

Other information:
- To access / replace the SRS control module and connector, see Supplemental restraint system module (SRS), replacing Service and Repair.
- To access/replace the side impact sensor, see Collision sensor, replacing Service and Repair.
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Supplemental Restraint System Module (SRS).
- For other values, see Signal specification Signal Description, Supplemental Restraint System (SRS) Control Unit.









Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Exit fault-tracing

------------------------

Attempt New Test - Intermittent fault

-------------------------------------------------