Transfer Case Vent

Transfercase ventilation valve

Removing the brass pipe
Remove the bevel gear. Bevel Gear, Replacing




Pull out the brass pipe using cutting nippers.




Tap in the nipple using a rubber mallet.
Install the filter on the nipple.

Filling with oil
Position the bevel gear so that it is standing on the oil pan (as it is located in the car).
Remove the level plug. Fill with oil (P/N 1161648) until the oil runs out of the level plug hole.

Caution! Then drain 0.2 l of oil.

Install the level plug. Tighten to applicable specifications.
Install the bevel gear. Bevel Gear, Replacing