Accumulator / Receiver Drier, Replacing

Accumulator / Receiver Drier, Replacing

NOTE: Chassis number limit, see below: S60 with chassis no. from and including 471445, see: Receiver drier, replacing. S80 with chassis no. from and including 409455, see: Receiver drier, replacing. V70 manufactured in Sweden (factory code: 1) with chassis no. from and including 506584 and V70 manufactured in Belgium (factory code: 2) with chassis no. from and including 505663, see: Receiver drier, replacing. XC70 with chassis no. from and including 195820 see: Receiver drier, replacing.

Removal

Removing the drier







Remove the condenser.

Remove:
- the intermediate pipe acc. to: Pipe receiver drier, replacing
- the pipe coupling from the condenser
- the screw for the bracket
- the drier / receiver.

Installing the receiver drier

NOTE: Always use new O-rings lubricated with compressor oil.

Position the receiver / dryer on the bracket and mount the pipe from the condenser.

Thread in the screw for the bracket.

Tighten the screw for the condenser-receiver/dryer's pipe coupling.

Tighten to 10 Nm

Tighten the screw for the bracket.

Tightening torque 25 Nm

Install the condenser acc. to: Condenser, replacing.