Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking wiring and terminals
Check the wiring between the control module for the steering wheel angle sensor terminal #4 (#A28) and steering wheel module terminal #3 (#A3). Check for a short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.

Other information:
- To connect the breakout box to the control module for the steering wheel angle sensor, see Signal description, Control unit for the steering wheel angle sensor (SAS) Signal Specification
- To connect the breakout box to the steering wheel module, see Connecting the breakout box Connecting the Breakout Box, Steering Wheel Module (SWM)
- For information about signals to the control module for the steering wheel angle sensor, see Signal description, Control unit for the steering wheel angle sensor (SAS) Signal Specification
- For information about signals to the steering wheel module, see Signal specification Signal Specification, Steering Wheel Module (SWM).










Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking wiring and terminals

FAULT FOUND - Fault Found

-------------------------------------------------