Signal Too High. Permanent Fault

Signal too high. Permanent fault

Replacing the component
Replace the Rear fog lamp relay (position 2/49). Check the relay terminal, in particular relay guide 2/49 terminal #2, for a short-circuit to supply voltage.
Remedy as necessary

Other information:
- For further information about signals and other values, see Signal specification Pinout Values and Diagnostic Parameters
- To access and replace the relay, see Integrated relay/fuse box cargo compartment/rear electronic module, replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing
- When the relay is installed and activated, the voltage at the relay guide (terminal #2) must be 0 V
- Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.










Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After the repair it is necessary to check that the fault has been rectified.








- Ignition off.
- Install the components, connect the connectors, etc.
- Ignition on.
Activate rear fog lamps.





Do the rear fog lamps work?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - Fault Found

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

Attempt New Test - Replacing the component

FAULT-TRACING FAILED - No Fault Found

-------------------------------------------------