Signal Too High. Permanent Fault
Signal too high. Permanent fault
Checking the wiring
Check the power supply cable between rear electronic module connector terminal #B20 (#D20) and tilt sensor connector terminal #1. Check for a short-circuit to supply voltage.
Other information
- For further information about signals and other values, see Signal specification Pinout Values and Diagnostic Parameters
- To connect the breakout box, see Integrated relay/fuse box cargo compartment/rear electronic module, replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing
- To access the rear electronic module, see Connecting the breakout box Connecting Breakout Box, Rear Electronic Module (REM)
- Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Continue - Verification
-------------------------------------------------
Verification
Verification
Verification
Hint: After the repair it is necessary to check that the fault has been rectified.
- Ignition off.
- Connect the connectors, install the components, etc.
Open the boot lid and lock in the open position by pressing in the lock hinge.
Lock the car by remote control.
Wait for 25 seconds until the alarm is activated and sound the alarm by releasing the level sensor and turning it.
Is function OK?
Yes - VERIFIED
No - VERIFICATION FAILED
------------------------
VERIFIED - Fault Found
VERIFICATION FAILED - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - FAULT-TRACING FAILED
No - Attempt New Test
------------------------
Attempt New Test - Checking the wiring
FAULT-TRACING FAILED - No Fault Found
-------------------------------------------------