Signal Too Low. Intermittent Fault

Signal too low. Intermittent fault

Checking wiring and connectors
Check the cables between connector terminal #7 for the fuel level sensors and control module terminal #A08 (#A8). Check for an intermittent short-circuit to ground. Check for an intermittent open-circuit.
Check the ground lead between control module terminal #A10 (#A10) and fuel level sensor connector terminal #6. Check for an intermittent open-circuit.
Check the cables between the left and right fuel level sensors. Check for an intermittent open-circuit.

Other information:
- For further information about signals and other values, see Signal specification Pinout Values and Diagnostic Parameters
- To connect the breakout box, see Connecting the breakout box Connecting Breakout Box, Rear Electronic Module (REM)
- To access the control module, see Integrated relay/fuse box cargo compartment/rear electronic module, replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing
- To access the fuel level sensors, see Left fuel gauge sensor Left Fuel Gauge Sensor and Right side fuel pump with level sensor Right Side Fuel Pump With Level Sensor
- Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.










Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

FAULT FOUND - Fault Found

Attempt New Test - Checking wiring and connectors

-------------------------------------------------