Signal Too High or Signal Missing. Permanent Fault

Signal too high or Signal missing. Permanent fault

Checking wiring and connectors
Check the resistance of the fuel level sensor (right-hand side). The resistance across each sensor may vary between 12 ohms (full fuel tank) and 383 ohms (empty fuel tank).

Hint: The resistance of the right-hand side fuel level sensor can be measured between fuel level sensor connector terminals #7 and #6. The resistance of the left-hand side fuel level sensor can be measured between fuel level sensor connector terminals #5 and #6.

Check the cables and connections between connector terminal #7 for the fuel level sensors and control module terminal #A08 (#A8). Check for an open-circuit. Check for a short-circuit to ground. Check for a short-circuit to supply voltage.
Check the ground lead between control module terminal #A10 (#A10) and connector terminal #6 for the fuel level sensors. Check for an open-circuit.
Check the cables between the left and right fuel level sensors. Check for an open-circuit.
Remedy as necessary.

Other information:
- For further information about signals and other values, see Signal specification Pinout Values and Diagnostic Parameters
- To connect the breakout box, see Connecting the breakout box Connecting Breakout Box, Rear Electronic Module (REM)
- To access the control module, see Integrated relay/fuse box cargo compartment/rear electronic module, replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing
- To access the fuel level sensors, see Left fuel gauge sensor Left Fuel Gauge Sensor and Right side fuel pump with level sensor Right Side Fuel Pump With Level Sensor
- Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.










Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After the repair it is necessary to check that the fault has been rectified.








- Ignition off.
- Install the components, connect the connectors, etc.
- Make sure there are more than two litres of fuel in the right tank half.
- Ignition on.
Read the fuel level in the right tank half.





Is the value normal?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - Fault Found

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

Attempt New Test - Checking wiring and connectors

FAULT-TRACING FAILED - No Fault Found

-------------------------------------------------