Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information ECM-2100

Condition




The engine control module (ECM) checks the signal from the fuel pressure sensor. Diagnostic trouble code (DTC) ECM-2100 is stored if the engine control module (ECM) registers that the signal from the fuel pressure sensor is too high or too low. The diagnostic trouble code (DTC) is diagnosed when the ignition is switched on or with the engine running.
For information about fuel pressure regulation, see VIDA Design and Function.

Substitute value
Diagnosis for fuel pressure regulation switched off.

Possible source

Signal too high:
- Contact resistance or oxidation in the terminals
- Short-circuit to supply voltage in the signal cable
- Open-circuit in the signal cable
- Open-circuit in the signal ground cable
- Defective fuel pressure sensor.

Signal too low:
- Short-circuit to ground in the signal cable
- Defective fuel pressure sensor.

Fault symptom[s]
- Malfunction indicator lamp (MIL) lit
- Deterioration in performance
- The engine stops.