Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking the generator (GEN)




- Ignition off
- Disconnect the 1-pin connector from the generator (GEN) (1B)
- Start the engine.
Check that the voltage does not exceed 16 volts at 2,000 rpm.
Remedy as necessary.

Other information:
- To access the central electronic module (CEM), see Central electronic module (CEM), replacing Central Electronic Module (CEM), Replacing
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- The generator (GEN) connector for gasoline engines, see Generator, replacement Service and Repair
- The generator (GEN) connector for diesel engines, see Generator (GEN), replacing Service and Repair






Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking the generator (GEN)

FAULT FOUND - DONE

DONE - DONE

-------------------------------------------------