Rear Knuckle: Service and Repair

Wheel knuckle rear

Note! Some variation in the illustrations may occur, but the essential information is always correct.

Removal

Note! Removal steps in this procedure may contain installation details.

Remove the following items:
- spring. Refer to: Spring rear, replacing, M66, TF-80SC, AW55-50/51SN, M56 Spring Rear, Replacing
- brake shoes. Refer to: Handbrake, brake shoes, replacing Service and Repair
- wheel hub. Refer to: Rear wheel hub, replacing, M66, TF-80SC, AW55-50/51SN, M56 Rear Wheel Hub, Replacing




Torque: M6, 10 Nm




Torque: M12, 80 Nm




Torque: M8, 24 Nm

Installation

Note! Only tighten the nuts and screws when the suspension is in the normal drive position.

Follow the instruction. Refer to: Tensioner, instructions for use, M66, TF-80SC, AW55-50/51SN, M56 Tensioner, Instructions For Use

To install, reverse the removal procedure.

Check the rear wheel alignment. Refer to: Wheel alignment, checking / adjusting Service and Repair