Checking the Rear Fog Lamp (Germany)

Checking the rear fog lamp (Germany)

Checking the market
The following fault-tracing only applies to cars intended for the German market.

Is the test applicable?

Yes - Checking the relay

No - No Fault Found

-------------------------------------------------

Checking the relay
Check the function of relay 2/83: Activate and deactivate the relay a number of times. The relay is functioning if there is a clicking sound when the relay is activated and deactivated.
Replace with a new relay if the relay does not function.

Other information:
- To access and replace the integrated relay/fusebox in the cargo compartment, see Integrated relay/fuse box cargo compartment/rear electronic module, replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing.









Was a fault detected?

Yes - Fault Found

No - Checking components and wiring

-------------------------------------------------

Checking components and wiring
Check that shunt 20/29 is not damaged. The resistance between the terminal pins is 0 ohm to 5 ohms depending on which pin the reading is taken at.
Check the cable between relay 2/83 terminal #3 and the left and right lower lamp housing connectors terminal #3A. Check for an open-circuit. Check for a short-circuit to ground.
Check the cable between the left and right upper lamp housing connectors terminal #4A and the ground terminal for an open-circuit.
Check that fuse 11D/2 is intact.
Remedy as necessary.

Other information:
- For further information about signals and other values, see Signal specification Pinout Values and Diagnostic Parameters
- To connect the breakout box, see Connecting the breakout box Connecting Breakout Box, Rear Electronic Module (REM)
- To access the integrated relay / fusebox in the cargo compartment, see Integrated relay/fuse box cargo compartment/rear electronic module, replacing Integrated Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing
- Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.













Was a fault detected?

Yes - Fault Found

No - No Fault Found

-------------------------------------------------