Back Window Glass: Service and Repair

Rear windscreen

Special tools:
951 2925 Rollout 2000 951 2925 Rollout 2000

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing the rear windshield





Remove:
- the upper panels on the C-pillars. C-Pillar Trim Panel
- the wiring from the rear windshield.




Lubricate the windshield weatherstrip using soap solution.
Feed the wire down around the windshield and secure with tape at the top edge.
Tension the wire when going around the corners to ensure it remains in place.




Pull in the surplus wire as illustrated.




Secure the long wire to the winch.





Caution! Protect the parcel shelf and the panels using the parabolic chisel or the plastic disc.




Secure a winch. Winch in the long wire.




Release the winch from the windshield. Pull out the lug (1) and move the winch.

Note! Hold the roll secure with your fingers so that the wire does not spin off.




Secure the winch in the new position.




Secure the winch (2).









Installation

Installing the rear windshield
Bond the rear windshield in place. Service and Repair

Install:
- the wiring on the windshield
- the upper panels on the C-posts. C-Pillar Trim Panel