Front Bumper Cover / Fascia: Adjustments

Air baffle, adjusting

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Adjustment

Adjusting the protective cover




Cut off two of the snap fasteners (1).

Note! Do not touch the other snap fasteners (2).








Use a 5 mm bit to drill two holes - one on each side -just below where the snap fasteners previously were.




Locate the holes in the member for both cable ties. Insert one cable tie through one of the holes and do the same on the other side.




Before fitting the protective cover against the member, insert the cable ties through the drilled holes.




Press the protective cover against the member and make sure the snaps lock against the member. Finish by tightening the cable ties and cutting of the excess.