Connecting the Breakout Box, Subwoofer Module (SUB)

Connecting breakout box

Special tools:
951 2843 Adapter 951 2843 Adapter
951 1428 Breakout box 951 1428 Breakout Box

Connecting breakout box




- Ignition off
- Expose the subwoofer module (SUB).
Connect adapter951 2843 Adapter 951 2843 Adapter to the control module connector (wiring side). Connect breakout box951 1428 Breakout box 951 1428 Breakout Box to the adapter. Subwoofer module (SUB) terminals #A1-#A4 correspond to terminals #51-#54 on the breakout box.
The breakout box is designed to facilitate reading off the control module input and output signals when the control module is connected and cable and component resistance when the control module is disconnected. The use of a breakout box reduces the risk of accidental short-circuited cables and damage to the connector pins.

Disconnecting breakout box
In reverse order.

Note! Before the control module can be checked and readings taken, the removed fuses must first be installed.

Other information
- Signal specification Signal Description, Subwoofer Module (SUB)
- For further information about the fuses and ground point, see the Wiring Diagram.