AM/FM Tuner Module (AFM)

AM/FM Tuner Module (AFM)

Diagnostic functions

General

The control module has a built-in diagnostic system, Volvo Diagnostic, which continuously monitors internal functions as well as input and output signals.

Diagnostic trouble codes (DTCs)

A diagnostic trouble code (DTC) is stored if the control module detects a fault. If for some reason a fault disappears after the diagnostic trouble code (DTC) has been permanently stored in the control module, information about the fault is stored in the control module.

Reading and erasing diagnostic trouble codes (DTCs)
Stored diagnostic trouble codes (DTCs) can be read off and erased using this function

Diagnostic trouble codes (DTCs) can only be erased once all the diagnostic trouble codes (DTCs) have been read off at least once.

NOTE: Certain functions are unavailable until the diagnostic trouble codes (DTCs) have been erased.

Reading off input and output signals

This function can be used to continuously read off the values and status of the control module's input and output signals.

The following parameters can be read off:
- Waveband. Which waveband is activated; AM/FM/Off
- Frequency. Indicates the AM/FM frequency which is set.

Reading off the control module identification
VIDA identifies control modules by reading off a number of codes from the control module memory.
The codes contain information about the control module:

- hardware P/N (control module without software)
- hardware serial number (control module without software)
- software P/N
- diagnostic software P/N.

Reading off extended fault-tracing information

This function can be used to read parameters, status identifiers and counters stored at the same time as a diagnostic trouble code (DTC). These are called frozen values.