Antenna Amplifier: Service and Repair
Antenna amplifier, radio
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.
Removal
Removing the amplifier
Remove:
- the C-post panel. See: C-pillar trim panel C-Pillar Trim Panel
- the 3 connectors
- 1 M6 screw.
Remove the amplifier. Use an electrician's screwdriver at the top edge to release the clip.
Installation
Note! For tightening torques, see Specifications. [1][2]Specifications
Installing the amplifier
Install:
- the amplifier
- 1 M6 screw.
- the 3 connectors
- the C-post panel. See: C-pillar trim panel C-Pillar Trim Panel