Checking Resistance

Checking Resistance







- Ignition off.
- Disconnect the 8-pin transmission connector.

Check the solenoid SLS circuit by measuring the resistance between terminals #5 and #6 on the 8-pin transmission connector.

The ohmmeter should read 5 - 5.6 Ohms (at 20 degree C).

Other information:
- To disconnect the transmission connectors, see Transmission connectors.
- For information about signals, see Signal description. Transmission control module (TCM).

Was the resistance OK?

YES: Continue with Next Procedure. Refer to Checking The Wiring.
NO: Refer to Checking The Wiring And Component. Checking The Wiring And Component