R.H.D.

Signal missing

Checking the component
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults can occur for a number of different reasons. The fault is evaluated depending on how it occurs.
Check the fuse for the power seat module (PSM).
Check the signal cable between control module terminal #A4 and seat motor 3. Check for an open-circuit. Check for contact resistance.
If a fault is found, replace the signal cable.
Try replacing the motor if no fault is found.
Remedy as necessary.

Other information:
- Electric motor height adjustment Electric Motor Height Adjustment
- Electric motor front-rear adjustment Electric Motor Front-Rear Adjustment
- Checking wiring and terminals Checking Wiring and Terminals
- Signal specification, R.H.D Signal Description, Power Seat Module (PSM)
- For information about the fuses, see the relevant wiring diagram.






Continue - Verification

-------------------------------------------------

Verification




Verification seat operation

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that seat operation functions. Move the seat manually in all directions.

Does the seat operation function?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the component

-------------------------------------------------