Stuck In the Active Position

Stuck in the active position

Replacing the component
A condition of the fault-tracing is that the diagnostic trouble code (DTC) is not stored because the memory button has been held in for too long.
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults can occur for a number of different reasons. The fault is evaluated depending on how it occurs.
Replace the power seat module (PSM) in the event of a permanent fault.
Remedy as necessary.

Other information:
- Control module front seat Service and Repair Control module front seat Service and Repair.






Continue - Verification

-------------------------------------------------

Verification




Verification seat operation

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that seat operation functions. Move the seat manually in all directions.

Does the seat operation function?

Yes - Fault Found

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

-------------------------------------------------