L.H.D.

Short-circuit to ground

Checking for a short-circuit
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults can occur for a number of different reasons. The fault is evaluated depending on how it occurs.
Check the signal cable between control module terminal #A2 and seat motor 1. Check for a short-circuit to ground.
Check the signal cable between control module terminal #A3 and seat motor 2. Check for a short-circuit to supply voltage.
Check the signal cable between control module terminal #A4 and seat motor 3. Check for a short-circuit to ground.
Check the signal cable between control module terminal #A5 and seat motor 4. Check for a short-circuit to ground.
Check the signal cable between control module terminal #A6 and the seat motors. Check for a short-circuit to ground.
If a fault is found, replace the signal cable.
Remedy as necessary.

Other information:
- Electric motor height adjustment Electric Motor Height Adjustment
- Electric motor front-rear adjustment Electric Motor Front-Rear Adjustment
- Electric motor, backrest rake Electric Motor, Backrest Rake Electric motor, backrest rake Electric Motor, Backrest Rake
- Checking wiring and terminals Checking Wiring and Terminals
- Signal specification, L.H.D Signal Description, Power Seat Module (PSM)






Continue - Verification

-------------------------------------------------

Verification




Verification seat operation

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that seat operation functions. Move the seat manually in all directions.

Does the seat operation function?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - Fault Found

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking for a short-circuit

-------------------------------------------------