Signal Too High

Signal too high

Checking the component and wiring
Check the power supply cable between engine control module (ECM) terminal #B17 (#C17) and starter relay terminal #1. Check for an open-circuit.
Check the signal cable between engine control module (ECM) terminal #B8 (#C8) and starter relay terminal #2. Check for a short-circuit to ground.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting The Breakout Box, Engine Control Module (ECM)
- Signal specification Signal Specification, Engine Control Module (ECM)
- Checking wiring and terminals Checking Wiring and Terminals






Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Start the engine.
The fault has been remedied if the engine starts.

Does the engine start?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - Fault Found

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the component and wiring

-------------------------------------------------