Signal Too Low

Signal too low

Checking the status




- Start the engine.
Check whether the fault is permanent or intermittent. Read off the fault status from the camshaft position (CMP) sensor. When the camshaft position (CMP) sensor is tested, "Diagnostic ready" must be displayed.
The fault is permanent if the fault status is "Fault found". The fault is intermittent if the fault status is "No fault detected".










Continue - Checking the component and wiring

-------------------------------------------------

Checking the component and wiring
Check the signal cable between engine control module (ECM) terminal #A60 (#A60) and camshaft position (CMP) sensor connector terminal #3. Check for a short-circuit to ground.
Check the power cable between engine control module (ECM) terminal #A16 (#A16) and camshaft position (CMP) sensor connector terminal #1. Check for an open-circuit.

Hint: With the ignition on and the camshaft position (CMP) sensor connector disconnected, the voltage between terminal #1 and ground terminal should be approximately 5 V.

Remedy as necessary.

Other information
- Connecting the breakout box Connecting The Breakout Box, Engine Control Module (ECM)
- Signal specification Signal Specification, Engine Control Module (ECM)
- Camshaft position sensor (CMP) Service and Repair
- Checking wiring and terminals Checking Wiring and Terminals














Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Reinstall the connectors, components etc.
- Start the engine.
Check the fault status of the camshaft position (CMP) sensor when the sensor is tested. When the camshaft position (CMP) sensor is tested "Diagnostic ready" must be displayed and the fault status must be "No fault detected".





Is the fault status "No fault detected"?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - Fault Found

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the status

-------------------------------------------------