Signal Too Low

Signal too low

Checking the component and wiring
Check between terminals #1 and #2 in the injector that relates to the diagnostic trouble code (DTC). Check the resistance.
Check the cable that relates to the diagnostic trouble code (DTC). Check for a short-circuit to ground.
Check between:
- Engine control module (ECM) terminal #A1 (#A1) and injector terminal #2 (ECM-2310).
- Engine control module (ECM) terminal #A25 (#A25) and injector terminal #2 (ECM-2320).
- Engine control module (ECM) terminal #A3 (#A3) and injector terminal #2 (ECM-2330).
- Engine control module (ECM) terminal #A2 (#A2) and injector terminal #2 (ECM-2340).
- Engine control module (ECM) terminal #A26 (#A26) and injector terminal #2 (ECM-2350).
Remedy as necessary.

Other information
- Connecting the breakout box Connecting The Breakout Box, Engine Control Module (ECM)
- Signal specification Signal Specification, Engine Control Module (ECM)
- Component specifications [1][2]Electrical Specifications
- Fuel injection supply manifold Service and Repair
- Checking wiring and terminals Checking Wiring and Terminals














Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Fault Found

------------------------

Attempt New Test - Checking the component and wiring

-------------------------------------------------