Signal Too High

Signal too high

Checking the status




- Start the engine and run it to normal operating temperature.
Check whether the fault is permanent or intermittent by reading off the signal from the fuel pressure sensor. With the engine at operating temperature and idling, the signal must be approximately 400 kPa.
The fault is permanent if the signal is incorrect. The fault is intermittent if the signal is correct.










Continue - Checking the component and wiring

-------------------------------------------------

Checking the component and wiring
- Check the fuel pressure sensor connectors. Check for contact resistance and oxidation.
Check the signal cable between engine control module (ECM) terminal #A91 (#B31) and fuel pressure sensor terminal #4. Check for a short-circuit to supply voltage. Check for an open-circuit.
Check the ground lead between engine control module (ECM) terminal #A15 (#A15) and fuel pressure sensor terminal #1. Check for an open-circuit.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting The Breakout Box, Engine Control Module (ECM)
- Signal specification Signal Specification, Engine Control Module (ECM)
- Pressure sensor, fuel rail (FRP) Service and Repair
- Checking wiring and terminals Checking Wiring and Terminals














Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reconnect the connectors, reinstall components etc.
- Start the engine and run it to normal operating temperature.
Read off the fuel pressure sensor signal. Check that the fuel pressure is approximately 400 kPa with the engine idling at operating temperature.





Is the value correct?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - Fault Found

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the status

-------------------------------------------------