Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information ECM-130A

Condition




The engine control module (ECM) calculates the anticipated mass air flow. The calculation is based on a number of parameters. The calculated value for mass air flow is divided (/) by the measured value from the mass air flow (MAF) sensor (=correction value, mass air flow). The diagnostic trouble code (DTC) is stored if the correction value deviates too much from 1, i.e. the calculated mass air flow is lower (Signal too low) or higher (Signal too high) compared with the measured mass air flow.
The diagnostic trouble code (DTC) can be diagnosed when the engine is running.

Substitute value
- None.

Possible source

Signal too high
- Air leakage in the intake system
- Blocked intake system
- Damaged sensor.

Signal too low
- Damaged sensor.

Fault symptom[s]
- Malfunction indicator lamp (MIL) lit.