Brake Pedal Position Sensor, Faulty Signal. Signal Too Low. Intermittent Fault

Signal too low. Intermittent fault

Checking wiring and connectors
Check the signal cable between engine control module (ECM) terminal #B16 and brake pedal sensor terminal #2. Check for a short-circuit to ground.

Other information
- To connect the breakout box, see Connecting the breakout box, B5234T9, B5244T7 Connecting The Breakout Box
- For information about signals, see Signal specification Signal Specifications
- Checking wiring and terminals Checking Wiring and Terminals














Continue - Fault-tracing information
DONE

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking wiring and connectors

FAULT FOUND - DONE

-------------------------------------------------