Brake Pedal Position Sensor, Faulty Signal. Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking wiring and connectors
Check the brake pedal sensor connector. Check for loose connections.
Check the signal cable between engine control module (ECM) terminal #B16 and brake pedal sensor terminal #2. Check for an intermittent open-circuit. Check for an intermittent short-circuit to supply voltage.
Check the signal cable between engine control module (ECM) terminal #B4 and brake pedal sensor terminal #2. Check for an intermittent open-circuit. Check for an intermittent short-circuit to supply voltage.

Other information
- To connect the breakout box, see Connecting the breakout box, B5234T9, B5244T7 Connecting The Breakout Box
- For information about signals, see Signal specification Signal Specifications
- Checking wiring and terminals Checking Wiring and Terminals.














Continue - Fault-tracing information
DONE

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking wiring and connectors

FAULT FOUND - DONE

-------------------------------------------------