Signal Too Low. Permanent Fault

Signal too low. Permanent fault

Checking components and wiring
This Diagnostic Trouble Code (DTC) means that SET+ and SET- are both active at the same time.
Try a new cruise control stalk.

Other information:
- To access or replace the cruise control lever, see Replacing cruise control lever/turn signal indicator switch Replacing Cruise Control Lever/Turn Signal Indicator Switch
- For information about signals, see Signal specification Signal Specifications.






Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking components and wiring

-------------------------------------------------