Signal Too Low

Signal too low

Checking components and wiring
Check the signal cable between engine control module (ECM) terminal #A12 and VGLA control module terminal #B22. Check for a short-circuit to ground.
Remedy as necessary

Other information:
- To connect the breakout box / access the control module, see Connecting the breakout box, B5234T9, B5244T7 Connecting The Breakout Box
- To access or replace the VGLA control module, see Replacing the control module Replacing the Control Module
- For information about signals, see Signal specification Signal Specifications
- Checking wiring and terminals Checking Wiring and Terminals.





Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition off
- Reinstall the connectors, components etc.
- Ignition on
- Check that the engine cannot be started when the clutch pedal is unaffected
- Check that the engine can be started with the clutch pedal pressed down.
The fault has been remedied if the function is OK.

Is function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking components and wiring

-------------------------------------------------