Signal Too Low

Signal too low

Checking the wiring
Check the signal cable between engine control module (ECM) terminal #B34 (#B44) and leak diagnostic unit terminal #2. Check for a short-circuit to ground.
If no fault is found in the above fault-tracing and the fault recurs. Try a new leak diagnostic unit.
Remedy as necessary.

Other information:
- For resistance values, see Component specifications Specifications
- To connect the breakout box, see Connecting the breakout box, B5234T9, B5244T7 Connecting The Breakout Box
- For information about signals, see Signal specification Signal Specifications
- To access or replace the leak diagnostic unit, see Leak diagnostic pump, replacing Service and Repair
- Checking wiring and terminals Checking Wiring and Terminals.













Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking the wiring

-------------------------------------------------