Signal Too Low

Signal too low

Checking the status




- Ignition on.
Activate the valve in the leak diagnostic unit to check whether the fault is permanent or intermittent.
The valve clicks when it is activated.
The fault is permanent if the valve does not activate.
The fault is intermittent if the valve activates.





Continue - Checking the wiring

-------------------------------------------------

Checking the wiring
Check the signal cable for the valve between control module terminal #B40 (#B50) and leak diagnostic unit terminal #3. Check for a short-circuit to ground.
Remedy as necessary.

Other information:
- Checking wiring and terminals Checking Wiring and Terminals
- For resistance values, see Component specifications Specifications
- To connect the breakout box, see Connecting the breakout box, B5234T9, B5244T7 Connecting The Breakout Box
- For information about signals on 5 cylinder engines, see Signal specification Signal Specifications
- For information about signals on 6 cylinder engines, see Signal specification Signal Specifications
- To access or replace the leak diagnostic unit, see Leak diagnostic pump, replacing Service and Repair













Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition on
- Activate the valve in the leak diagnostic unit.
The valve should click.
Check that the function is OK.









Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the status

-------------------------------------------------