Signal Too High. Permanent Fault

Signal too high. Permanent fault

Checking the wiring and component
Check the Intake Air Temperature (IAT) sensor resistance.
Check the signal cable between control module terminal #A5 (#A5) and intake air temperature sensor terminal #1. Check for a short-circuit to ground.

Hint: With the ignition on and the intake air temperature (IAT) sensor connector disconnected, the voltage between terminal #1 and ground must be approximately 5 V.

Remedy as necessary.

Other information
- To connect the breakout box / access the control module, see Connecting the breakout box, B5234T9, B5244T7 Connecting The Breakout Box
- To access or replace the intake air temperature (IAT) sensor, see Temperature and pressure sensor, replacing Engine Temperature Sensor
- For resistance values, see Component specifications Specifications
- For information about signals on 5 cylinder engines, see Signal specification Signal Specifications
- For information about signals on 6 cylinder engines, see Signal specification Signal Specifications
- Checking wiring and terminals Checking Wiring and Terminals.













Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reconnect connectors, reinstall components
- Ignition on.
- Read off the intake air temperature (IAT).
The Intake Air Temperature (IAT) sensor is integrated into the Mass Air Flow (MAF) sensor.









Is the temperature within its permitted range?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the wiring and component

-------------------------------------------------