Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Intermittent fault




- Ignition off.
Check the wiring between control module terminal A51 and transmission connector terminal T (#A17) for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Check the wiring between control module terminal A53 and transmission connector #E (#A5) for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Remedy as necessary.

Other information:
- To connect the breakout box, see Connecting the breakout box, B8444S, TF-80SC AWD Connecting the Breakout Box.
- To connect the breakout box to the transmission connector, see Connecting the breakout box, GM automatic transmissions Connecting the Breakout Box, GM Automatic Transmissions.
- For information about signals, see Signal specification Signal Specification.









Select Continue when the fault has been remedied.

Continue - Fault-tracing information
DONE

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - Exit Fault-Tracing

------------------------

Attempt New Test - Intermittent fault

-------------------------------------------------