Signal Missing. Permanent Fault

Signal missing. Permanent fault

Checking the wiring
Check the signal cable between rear electronic module (REM) connector #B06 (#D6) and tilt sensor connector terminal #2. Check for an open-circuit.
Also check both connectors for contact resistance and oxidation.
If no fault was found, try a new sensor.

Other information
- For further information about signals and other values, see Signal specification Signal Specification
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box
- To access the rear electronic module (REM), see Relay/fuse box cargo compartment/Rear electronic module (REM), replacing Relay/Fusebox Cargo Compartment/Rear Electronic Module (REM), Replacing
- To access and replace the tilt sensor, see Tilt sensor alarm, replacing Service and Repair
- Checking wiring and terminals Checking Wiring and Terminals.









Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After the repair it is necessary to check that the fault has been rectified.








- Ignition off.
- Connect the connectors, install the components, etc.
Open the boot lid and lock in the open position by pressing in the lock hinge.
Lock the car by remote control.
Wait for 25 seconds until the alarm is activated and sound the alarm by releasing the level sensor and turning it.

Is function OK?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the wiring

-------------------------------------------------